Ip Address problems

[Scott C. Best]

Lee:

 	Heya. While not a RealVNC solution, the EchoVNC approach makes
this a bit easier. With EchoVNC, each of your support clients "logs into"
an echoServer, which acts as a relay when you fire up a Viewer to connect
to them. In the Viewer, you can get a simple list of "who's available"
to connect with, and can start connections with point&click. It helps
a lot, especially when the VNC client is behind a NAT'ing router and
the supported users don't know the first thing about IP addresses. :)

cheers,
Scott
http://www.echovnc.com


> I have a problem where hovering over the vnc icon on the task bar doent
> display the ip address.  This is a isolated problem as I have vnc
> installed on quite a few machines.  I know I can get the ip address
> other ways but this is sometimes difficult to explain to users.  Is
> there a setting that I need to configure to make the ip pop up when
> hovering over the icon?
>
>
> Thanks
> Lee Redden
> Tel:01924 836911
> Ext 111
> E-mail: leer "at" wlamb.co.uk